Engineering & Making
Stress as F/A and strain as ΔL/L: Hooke's linear region
Listen
Stress is internal force per unit area, σ = F/A, measured in pascals. Strain is the change in length divided by the original length, ε = ΔL/L₀, and has no units. In the linear-elastic region, stress is proportional to strain, σ = Eε, where E is the material's elastic modulus, also called Young's modulus.
What you will learn
- Calculate stress as σ = F/A and strain as ε = ΔL/L₀ with correct units
- Use Hooke's law, σ = Eε, to relate stress and strain in the linear-elastic region
- Explain how cross-sectional area and elastic modulus change stress and stretch
I am Atlas. Mechanics of materials starts with two definitions.
STRESS is internal force per unit area: σ = F/A. With force in newtons and area in square meters, stress is in pascals (1 Pa = 1 N/m²). Engineers usually quote megapascals (MPa) or gigapascals (GPa). The same force on a smaller area gives a larger stress, which is why a thin section, a notch, or a hole is where parts tend to fail.
STRAIN is how much a part stretches compared with its original length: ε = ΔL/L₀. Because it is a length divided by a length, strain has no units. A strain of 0.001 means the part stretched by 0.1 percent.
HOOKE'S LAW links them. Under small loads, most metals are linear-elastic: stress is proportional to strain, σ = Eε, and the part springs back when the load is removed. The constant E is the elastic modulus, also called Young's modulus. Steel has E of about 200 GPa and aluminum about 70 GPa, so under the same stress aluminum stretches nearly three times as much. Past a limit, the material stops behaving linearly and Hooke's law no longer applies.
Worked example. A steel rod 2 m long with a cross-section of 0.0005 m² carries a 50,000 N pull. 1. Stress: σ = 50,000 / 0.0005 = 100,000,000 Pa = 100 MPa. 2. Strain: ε = σ/E = (100 × 10⁶) / (200 × 10⁹) = 0.0005. 3. Stretch: ΔL = ε × L₀ = 0.0005 × 2 m = 0.001 m = 1 mm. Check: 100 MPa is well below the yield strength of common structural steel (about 250 MPa), so the rod is still in the linear region and Hooke's law applies.
Key words
- stress
- Internal force per unit area, σ = F/A, in pascals.
- strain
- Change in length divided by original length, ε = ΔL/L₀; it has no units.
- Hooke's law
- In the linear-elastic region, σ = Eε, with E the elastic (Young's) modulus.
Check yourself
Think about it
Why is it critical for structural engineers to keep stresses within the elastic region when designing bridges and buildings?